How come the casing for this tool is not listed in the parts list. According to the parts picture it is item #25.
This is the plastic housing.
I feel there is a weak spot in the design of the tool for the locking pin which locks the gear mechanism is located in a thin plastic housing that can not take the strain when untightening the disc retaining nut. It results in a cracked housing.
Apparently, to acquire this part is a problem for it is skipped over in parts list. How come?
Have you noticed this problem arrising with this tool?
Other than this canundrum, I've found this tool just what I needed at the time. It can make what otherwise would be a bear of a job into a pussy cat.
Where can I proceed from here?
Please respond to my email address;
ab_handycraft@hotmail.com
Thank you. Al Barnes