Poulan 260 Pro Chain Saw

[JALaswellSr]

My problem is locating the correct Model Number for this Chainsaw. I bought it new approximately 5 years ago and it has seen quite a bit of use.
The EPA tag is damaged but it did list a serial number which I think I was able to make out.
Serial Number 2150200594-5. It could also be 215D200594-5. Other than the 260 Pro I could find no other numbers except on the handle Foot Plate that had a telephone Number and a 952-051481 Number. If the serial number indicates a model number I would think it might be a 2150 type 5. It has an 18 inch/45 CM bar with the in bar adjustment.

Thanks for any help you can give me.

[UtahAV]

Hi JALaswellSr,

Poulan does have a model PP260 Chainsaw. We do not have a parts diagram for it at this time. What parts are you looking for and I will see if I can help.

Thanks!

-UtahAV
-Mark

[JALaswellSr]

Hi Mark:
Thanks for the reply. The in-tank fuel line became brittle and the fuel filter broke off.
I would like to replace the Fuel Filter (It appears to be a Ceramic Filter of some type), Priming bulb and all three fuel lines. Two of the lines appear to be the same size tubing and the third a little larger.

I would also like to know the availability of the Chain Oiler (pump) and tool required to properly place the drive spring on the shaft. (It puts the proper spacing on the spring to fit the gear.) Mine Oils but not adequately with the Poulan Oil.

The manufacture date on my saw is 2003. Only the "3" is still readable but I compared the EPA Label to my neighbors Poulan. I bought it in either 2003 or 2004.

Thanks again for the reply.
Jack

[UtahAV]

OK Jack, I have some part numbers for you. The fuel lines are a bit vague in their names but the packages give you extra line in two different diameters. I think you will have plenty to make all of the fuel connections.

Vent Line - 530069216
Line Kit - 530069247
Fuel Filter - 530095646
Primer Assembly - 530071835
Oil Pump Kit - 530071259
Oil Pump Pickup Kit - 530047663

I hope this helps! Good luck with your repair!

-UtahAV
-Mark

[JALaswellSr]

Thanks Mark for your help!
Jack