needing to locate a armature for a Black and decker Imapct driver

flywelder · 10-09-2009

Hi,
I need to replace the armature to my Black and Decker electric impact driver, model 6511. Three small copper wires have broken in the windings, I can see them, they are on the surface.

I attempted to locate this part on e replacement parts.com but no where can I find where I can enter the name of a part.

Numbers on the armature, that I see are as follows: 59778
or the 8 is a 9, I cannot clearly distinguish.
Also, there is C131 or it is C181, again I cannot clearly distinguish.

I welcome all help in locating this part and fixing this great tool!
Thanks
Flywelder
10-09-09

UtahAV · 10-12-2009

Hi flywelder,

I think finding any parts for your 6511 Impact Driver is going to be quite a challenge! I found a parts diagram of the tool which has hand written on it that the tool was discontinued on Nov 9th, 1970. The part number for the armature is 72320-31 but it to is discontinued and no longer available. I think your best bet is to call around to your local repair shops to see if by chance any of them still have one laying on a shelf.

Good luck and let us know how it turns out.

-UtahAV
-Mark

10-09-2009	#1 (permalink)
flywelder Member Join Date: Oct 2009 Posts: 1	needing to locate a armature for a Black and decker Imapct driver Hi, I need to replace the armature to my Black and Decker electric impact driver, model 6511. Three small copper wires have broken in the windings, I can see them, they are on the surface. I attempted to locate this part on e replacement parts.com but no where can I find where I can enter the name of a part. Numbers on the armature, that I see are as follows: 59778 or the 8 is a 9, I cannot clearly distinguish. Also, there is C131 or it is C181, again I cannot clearly distinguish. I welcome all help in locating this part and fixing this great tool! Thanks Flywelder 10-09-09

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-12-2009	#2 (permalink)
UtahAV Member Join Date: Aug 2009 Location: Salt Lake City, UT Posts: 273	Hi flywelder, I think finding any parts for your 6511 Impact Driver is going to be quite a challenge! I found a parts diagram of the tool which has hand written on it that the tool was discontinued on Nov 9th, 1970. The part number for the armature is 72320-31 but it to is discontinued and no longer available. I think your best bet is to call around to your local repair shops to see if by chance any of them still have one laying on a shelf. Good luck and let us know how it turns out. -UtahAV -Mark