LinkBack URL
About LinkBackscompressor runs up to about 90 psi then the hose from pump to the tank gets real hot and the pressure starts to drop. check valve is o.k. tried to check piston, but do not know how to get piston out of head?
|
|
|
|
|
|
poter-cable mdl c2002 type 3 |
Results 1 to 2 of 2
|
poter-cable mdl c2002 type 3
compressor runs up to about 90 psi then the hose from pump to the tank gets real hot and the pressure starts to drop. check valve is o.k. tried to check piston, but do not know how to get piston out of head?
get piston out of head
Hey c.w180,
Once you have removed item #13 screw from the case [there may be 2 of them..1 on each side] and slid the whole pump assy off the tank..[you may have to unhook the electrical also] you remove the screws from the housing and separate..then you will have access to the piston/pump/motor assy..4 screws on the top plate..[check item #104 tube seal for wear or breakage ] you may have a worn out piston/seal assy..a worn out or broken valve plate or just that darn tube seal letting air leak out while its try to pump up..
parts and breakdown avail at ereplacementparts.com..
[caution..this repair is not for the faint of heart..pregnant women..or left-handed people..]
hope this helps..?
cmoorejack
Reply With Quote
