Poulan Wood Shark.

[captdon7]

1. On the Poulan Model 1950 Wood Shark chain saw, can someone instruct me how the fuel line connections are made up between the gas tank, the 2 carburetor connections (inlet and outlet connections), and the return fuel lines? I don't understand why it will run just fine for a few minutes and then quit; and then will not start no matter how many times I try to restart it.

2. On the same chain saw, what is the proper gap between the rotor and the stator to create the spark for the spark plug?

Many thanks for any help you can give me.

Best of Regards,

Don Weaver
(409)771.8328 cell phone

[Dale]

On a 1950 type 1 the figure # is b14 part # is 530071835. it should be held in by two screws. hope this helps. The part# is the same for all types. But have different fig #s

[V0LC0M]

Hey there! Dales Advice for taking the Air box Assembly apart is spot on! A purge bulb can be ordered from eReplacementParts.com : Power Tool Parts and Tool Repair part number 530071835 to replace that old cracked one!


Hope this helps

Patrick

[ham radio man]

Im replacing all fuel hoses going to the Carb and prime bulb plus going into
the gas tank. Is it all the same size.
I see some with Part Number: 530069247 is that what I need.