can't remove table saw bearing

[Larry Kirby]

I have a Delta TS200LS table saw (type 1) . I'm trying to replace the rear motor bearing that burnt out but I can't even get it to move at all. Tried prying it out with a large screwdriver, even put two strong flat metals under the bearing and tapping it out with a hammer (both soft and hard hammers) but it won't even budge. I don't think it should be THAT tight but "SHOULD" don't mean anything. Any ideas I get would be a big help and thankfully recieved.

[cmoorejack]

Hey larry,
ideally a otc # 1020 puller should be used...here is something else you can try..secure the armature in a bench vise with the bearing end as close to the end of vise as possible..then take the 2 flat blade screwdrivers and place the tips behind the bearing and pry against the vise...[BE CAREFUL]...If you don't have a bench vice you may have to purchase a puller..
hope this has been helpful..and good luck..!
Craig
Geneva Tool Repair

[Dale]

You can try a little heat. If I was going to buy a puller I would go with the otc 1021 it has three legs. More strength. easier to use. ereplacementparts will stock this one soon. Worse come's to worse. you can always grind it off. take you time. and dont grind to much off.