Bosch 11241EVS Hammerdrill stripped gear

osmak · 11-16-2009

I have a 2 year old hammer drill that has been used 4 times.. it has stripped the gear on the end of the armature . Can anyone advise on why this would happen .. or are Bosch tools suffering from quality issues.

Dale · 11-17-2009

If you have only used it four times. I would take it to a Bosch service center. Tell them your story. and there's a good chance they will fix it under warranty. sound's like a manufacture defect.

osmak · 11-19-2009

I tried that .. and the repair person even called them to verify its was in new like condition... but they said NO!! I also sent them a couple of emails to their website explaining the situation , but they have failed to respond.

11-16-2009	#1 (permalink)
osmak Member Join Date: Nov 2009 Posts: 2	Bosch 11241EVS Hammerdrill stripped gear I have a 2 year old hammer drill that has been used 4 times.. it has stripped the gear on the end of the armature . Can anyone advise on why this would happen .. or are Bosch tools suffering from quality issues. Last edited by osmak; 11-16-2009 at 04:42 PM. Reason: spelling

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-17-2009	#2 (permalink)
Dale Member Join Date: Jul 2008 Location: Rocky Mountains Posts: 106	If you have only used it four times. I would take it to a Bosch service center. Tell them your story. and there's a good chance they will fix it under warranty. sound's like a manufacture defect.

11-19-2009	#3 (permalink)
osmak Member Join Date: Nov 2009 Posts: 2	I tried that .. and the repair person even called them to verify its was in new like condition... but they said NO!! I also sent them a couple of emails to their website explaining the situation , but they have failed to respond.