jkljkl

[lg1]

I have a DC925 and the clutch setting does not work. I can hold the chuck by hand with the drill running. What do I need to repair it?

[Mark]

Hi lg1,

It sounds to me like more of a transmission issue than a clutch problem. In fact my first guess would be that the gear selector on the transmission is sitting in between two gears. When this occurs it is as if the transmission is in a neutral position. The motor will run but the chuck can be stopped by just lightly grasping it.

If you confirm that it is not set in between the gears and the problem still persists then one or more of the gears in the transmission have likely failed. To make the repair you will need to replace the gearbox assembly. It is part #613237-00 and is available from http://ereplacementparts.com.

I hope this helps with your repair!

-Mark