saw stopped working

[Kent Adams]

Checked to make sure power was coming past the fuse into the motor. Checked the brushes - didn't appear to be in bad shape. Then tapped on the motor and then it started working. Could it be the brushes?

[Mark]

Hi Kent,

I would open the saw up and check the wiring for a loose connection. There is a circuit board inside as well that could be causing the problem. Make sure that the brushes slide easily in the brush holders. If not very lightly sand them with some fine sandpaper.

Good luck with your repair!

-Mark

[Mark]

if the brush is worn down to 3/8'', it must be replaced.
Use only identical DeWalt brushes as new brush assemblies are available. Always replace a used brush in the same orientation in the holder as it was prior to its removal. And keep them clean and sliding freely in their guides. As you must do maintenance to keep your saw running in top shape.

Canned air will help you clean out any carbon dust in the motor or guides.
Happy to help & Happy Scroll sawing