belt replacement

[rooter]

How do I change the poly V belt? Thanks

[Mark]

Hi Rooter,

The small poly belts can be a challenge to replace. They are not very pliable so trying to sliding them over each pulley can be frustrating. The secret we have found is to heat the belt first. Run the belt under hot water for a few minutes and then try to install. The heated belt will be much more flexible and you should now be able to slide it onto the pulleys.

I hope this helps with your repair!

-Mark

[OregonMike]

I changed this belt yesterday as follows: Remove the top cover to the lock shaft, then pull big drive wheel from planer shaft after locking it in place. Take care not to loose the square key. Boil some water and immerse the new belt. Run the belt around the big pulley as tight as you can and hook about a third of the belt over the small wheel. Pull the big wheel onto the shaft but don't put it all of the way in. Rotate the big wheel on the shaft to work the belt over the rest of small pulley. Reinsert the key and slide the pulley back on. Replace shaft screw etc.