Speed Control?

[jared]

The saw can still get up to full speed but it rarely does because of a "loose" connection. There are no wires that are hanging loose or anything, but you need to jiggle the wire where it goes into the motor to make it go for a second or two. The connections into and out of the controller are good so I'm guessing it's the controller itself. Is there any way to determine that or do I just have to start ordering parts until the saw works?

[Mark]

Hi Jared,

If jiggling the wires makes the problem go away I think I would start with wiring. It looks like there are several crimped junctions in the wiring. I would suspect a bad connection with one of them.

That would be my guess.

-Mark