replacing keyless chuck

[Craig Burr]

The parts list shows only one keyless chuck, for a threaded gear shaft. Mine does not seem to be threaded but has gear splines that I assume the chuck will be pressed over. The new chuck has no place for those splines to insert into. I ordered and got chuck #763154-1. Is there another?
Craig

[Mark]

Hi Craig,

It sounds like you have the proper chuck. Your drill should have a threaded spindle however. I am wondering if possibly there is still a portion of the old chuck threaded onto the spindle. The following link will take you to an article and video that shows the replacement of a drill chuck. Possibly it can provide some additional insight...

http://www.ereplacementparts.com/article/890/How_to_Remove_a_Drill_Chuck.html

I hope this helps!

-Mark