dewalt table saw motor

[rhill]

Was using my saw, motor quit replace worn brushes still would not start, have power to switch and thru?

[WJA]

Hello rhill,

I am guessing that your saw is either a DW744 or DW745. If you have continuity from the cord plug to the motor. Pull the brushes again and inspect the armature to make sure the commutator is not discolored or any of the bars are missing or raised higher than the others. Also check the brush holders, make sure there isn't any debris in them not letting the brushes make contact with the armature. You can also inspect the field connections to the motor cable.

Good luck,
WJA