Bosch 4000 Table saw grinding

[RichardGrzy]

I recently purchased a used Bosch 4000 10" table saw. The motor appears to have gotten wet. As a result the blade turns extremely slow and makes a very loud grinding noise. If anyone has any input as to which parts may need to be replaced I would greatly appreciate it.

Thanks,

Richard

[scline]

I recently purchased a used Bosch 4000 10" table saw. The motor appears to have gotten wet. As a result the blade turns extremely slow and makes a very loud grinding noise. If anyone has any input as to which parts may need to be replaced I would greatly appreciate it.

Thanks,

Richard

You might try replacing the brushes and you may have to take motor housing apart clean and the bushing and the armature use crokus cloth fine grit you can get at any hardware store in pluming part of the store the and put some white grease. I believe it is call lithium grease.

[zekeroo]

I had a similar problem with my bosch 4000. I took it apart and realized the rear bearing was corroded. I think it was from getting wet on jobsites. I replaced that and it works great now.