Push start sparks

[Jewelstoyou]

Been using my table saw for about three years as a DYIer. Today I cut three 2X6 and a *x 10 up with no problem. Then I went to cut a small piece of wood and the saw would not start,,Trird the trip switch nothing. I then touched the saw blade and it started to spin with lots of noise and sparks at the end of the motor? Turned it off and again had to push the blade to start it. Does anyone think it is only the brushes?? Also is there a simple way to get the motor out to check it? Thanks * Joseph

[ryobi_uk_warrenty_repair_centre]

have a check on the ryobi website
there are some call backs on some table saws
not sure if your model is one of them
because the model differs from europe to the usa
but check and see what the cross refference is
between your model in the usa
to the european model