Bosch Hammer Drill Switch Contacts Replacement

[671225]

I have a bosch 1199vsr hammer drill and can't figure out how to remove the brush holder to get access to the switch contacts to replace them. Any help would be appreciated. Thanks!
Derek

[Tinkerdave]

Hi anyango,
The brush assembly lifts out of the drill by rotating the assembly half way between forward and reverse .Lift with light force as you rotate between forward and reverse and you should see two springs aline with groves and it should lift out.Check your field contact closely as they sometimes get burnt and will burn out a new set of contacts it the don't make good contact.Hope this helps.good luck.
Tinker